Things That You Need To Know About Plasma Cutting
In plasma cutting, you must always look after your safety other than learning about a thing.
The plasma cutter has an electric circuit that is found between the so-called torch and the work object. When there is a motion that moves the work object, the electric circuit will most likely begin to move that said object as well. Avoid contact with the torch body or work object as it may affect not only the plasma cutting that is going on but also your life as well.
Basically, plasma cutting is a device that functions well in cutting any form of steel and other electrically conductive metals. However, the voltage electric arc and the compressed gas needed for the plasma cutter varies from one another and would usually depends on the type of steel, welding materials or other electrically conductive metals. An absolute high voltage electric arc is needed amounting to 100-200 volts to operate the plasma cutters unlike the welding cutter that normally carries lesser amount that the plasma cutter.
Never retrieve the work object when you are still doing the plasma cutting to avoid harm. Put the work object on the cutting bench spiraled by a ground table when the cutting process for the same is not still done. Another reminder is the ground clamp must stay stagnant while the plasma cutting process is still there. It is necessary to make sure that the ground cable is not removed and is still accompanied in the work object.
The etiquette that you should always be mindful about is that you should always use actually boots and gloves whenever you are doing the plasma cutting process because it will always make your body and garments dry.
Just don’t ever try to stand, sit, lie or touch any areas or surfaces that are wet especially in using the plasma cutter device. Make sure that the ground cable works well and connected to the work object when you are undertaking a plasma cutting process. You must entirely replace your plasma cutting machine If you have found out that your clamp is no longer usable or functioning.
It is always necessary to put on your proper eye protection just like wearing your gloves and boots when you are planning to do a plasma cutting. Learning that there are so-called arc rays producing dangerous ultraviolet and infrared waves that has the tendency to cause cataracts and skin problem when you don’t keep a proper eye protection. Start to begin with an end in mind by making sure that you are safe in doing the plasma cutting process and you can make it happen by wearing your protective clothes such as the gloves, welding safety shoes, welding the welding helmets, flame-retardant clothes, and trousers.
Source: plasma cutter